AEM V3 Universal Water-Meth Injection Kit 30-3300

AEM V3 Universal Water/Meth Injection Kit 30-3300

Water injection for gas engines is a proven means for effectively reducing engine inlet air temperatures and suppressing harmful detonation on forced induction and high performance naturally aspirated race engines. This allows racers to reliably increase boost and advance ignition timing -without using high-octane racing fuel- for power gains of up to 20%.

• Boost dependent controller with on-board MAP sensor

• Boost Safe readiness safety system

• Precision-machined billet-aluminum injector with integral check valve

• Three interchangeable injector nozzles to cover a wide variety of HP levels (250cc/min, 500 cc/min & 1,000cc/min)

• 1.15 gallon tank with integral conductive low-fluid sensor

• Internally-bypassed water injection pump does not cycle on an off and provides quiet, smooth operation. It features robust construction including integral hose fittings, EPDM seals and a Santoprene diaphragm that provides consistent and reliable fluid delivery

• LED dash light for system status

• 20 ft. of injection tubing